Fat tire minibike

I fixed it    need a different grease fitting for the front tho.

Did do a little test ride

what yall think

i like it!

thanks

Went to move it today and the rear lug nuts fell off   

also got a different grease zerk for the front hub

ya need a bigger clutch

I just geared down the mini bike from a 10-12 tooth sprocket on the engine side of the jack shaft

I am thinking about getting an led light bar for this i would eather get 2 6in or one 12 in what u guys think? It also ate the front bearings b/c they are not meant for the speed

some high speed bearings, and a sissy bar would be perfect LOL

Got new bearing and made a chain tensioner will make a video of that tomorrow

coolbeans, looking forward to it

As much as i hate to say it I think I am going to sell the mini bike to fund another project I am trying to get. If yall are close to me (New Orleans) and want it pm me with an offer

It will do burnouts    never even hit full throttle

so i maxed at 30mph and didnt want to go any faster. I did take a little video will be up later this week and this is how it sits today. I have added a front fender

just hit 40.2 mph on the minibike

It has been a while sense I last posted an update and that is because I haven't wanted to look or think about the mini bike. I shoved it in the back of my shed broken.
Here is what happened. About 4 months ago my friend and I took the newest go kart and the minibike to a place to go ride them. Every thing was fine for about 2mins. I started to go a little faster on the mini bike and I didn't see a hole on the trail. When I hit this hole it ripped the front tire off causing the front lower part of the frame to dig in and me to go over the handle bars and then the whole bike to go over my shoulder. I was wearing my helmet and only suffered some minor cuts and bruises. Still haven't fixed it but it should be fixed by the end of the summer.

Nice Mini bike. Like the X on the backbone. I did a mini bike for my kid, made the frame out of rebar and fence posts. and I'm making a low fatboy now. That has an 8 inch rear tire. If curios there on my channel

Thanks man, I will definitely check out your build. This is the current state of my bike.

I just read the post before mine. Wow, that must have hurt. Yah, no matter how strong you make the forks, they either bend or break. My kid hit a truck with the one I built for him and bent the hell out of the forks. Nothing but a BFH couldn't fix. Almost strait as an arrow, LOL. But good enough to keep ridding.