I got a late 90s murray that I built and need some help with mods. Any ideas?

Hey guys I got a late 90s murray that I built and need some help with mods. Any ideas?

Got any pics?

Gas pedal, pulley swap, 4 wheeler tires, bumpers, possibly a winch

Engine cage,exhaust,snorkel,wheely bar,brakes,....

check out my murray. link is right below this

Yeah I'm new to this so it may take me a second to upload them! xD

So far ive swapped the transaxle pulley to 3 inch, i did an engine swap from a 12 hp briggs to a 15hp sabre briggs, go kart rear a/t tires, paint job of course , new starter, tinted headlights with purple neon underglow and police strobes all around, new turf savers up front but very small, and through some blue balls on the back . i wanna beef up my steering and some exhaust and a bumper eventually, but i would like some other unique ideas, ive got most of the basics, any ideas?

Sweet how about a siren you maker miss my old Murray  

Bigger front pulley for more torque and speed

i like how crazykid1994 did the intake on his murray, ive been wanting to cold air or snorkel it just cant picture it out.

my speed is close to 20 mph so im good for that but my steering is weak and has so much play in it....

Have you tightened every thing in the stearing?

i have previously after painting and it did better but about a week ago the linkage from the steering box to the axle broke and i believe i fixed but since then it has had so much play but it had play before that though.

How is the steering bar bolted to the spindle if it is a ball joint then it may be worn out this has happened to me before

i really want setup direct steering but not sure how in the murray i have. it seems easy on every other mower   

Take a picture of the steering? Maybe we could help.

Take a picture of the steering? Maybe we could help. And it took me a while to finally decide how to do my snorkel/intake. Its all on how you like it

[img]https://i.servimg.com/u/f3[url=https://servimg.com/view/18450674/4]7/18/45/06/74/photo10.jpg[/img][/url]

I just don't see how it would work and I tightened that bolt up on the steering k2500life and its not as much play as before

Cool

You could extend your shaft that your steering wheel goes on through the bottom of the frame then make a piece that goes on the spindle. To help look here if you didnt already.

https://www.atltf.com/t1773-direct-steering-how-to-reference?highlight=direct+steer