Craftsman1998's Cub Cadet Puller build

Got the shifting linkage all hooked up. its not connected to the tranny yet.

Paint came out looking smooth and shiney, too bad about the dirt. It happens. I had a lot of trouble with gloss black turning out a grey color until I finally figured out it was from too much humidity.

Yeah the paint came out nice just need to buy some sand paper to fix the hood

Got the hood on

looks good! that cub yellow overspray gets everywhere don't it?

thats nice not bad but why that small of front tires thats a cool tractor check out my puller
in the pulling section (CRAFTSMAN)

lincolnmaniac wrote:

looks good! that cub yellow overspray gets everywhere don't it?

Thanks and yes it gets EVERYWHERE so when i paint i need to cover everything up

kawasaki220 wrote:

thats nice not bad but why that small of front tires thats a cool tractor check out my puller
in the pulling section (CRAFTSMAN)

I'm not using those tires i just took them off my rototiller so i could at least move it around instead of trying to lift a 700 pound tractor. I still need to find rims with 1 in holes but can't find any so i think i need to buy them from someone whose parting out a cub that has 1 in shafts. I would like to get them new so i can just paint it. Because if i get them used i'll have to clean and sand them.

yeah whites hard one mistake and it really shows

Removed

Primed it

First coat of paint

Used up the rest of my yellow paint on the tranny need to pick up more

Ordered paint today should be here this week

The paint has arrived so tomorrow i should have the tranny done and then i can put it in then i can put on the fenders.

Can't wait to see the old machine back in action again.

purddy

Looks good, did you try the new paintgun you got?

Thunderdivine wrote:

Looks good, did you try the new paintgun you got?

No i need to get a regulator for it. Dont know where to get the right on for it though

camomanusa wrote:

purddy

Yep its very purdy

Removed