Huskee Offroad Mower Build

I'm going to leave it stock for now. Is there a way to swap pulley without a welder ?

just buy a smaller pulley for the transaxle if you can get the pulley off.

What size are the pulley shafts ?

the one on the rear end should be 5/8", and the engine shaft is 1"

Thanks I see one at Tractor supply that a five inch will that work ?

If it is the same bore, then it should work. for every inch smaller pulley you use, shorten the belt by 1.57 inches
(1 1/2")

I changed my mind I'm going to build a train out of it for the kids. any info ?

take the body off and use push mowers for the cars

I was thinking a 55 gal steel drum for the hood

I think will build a offroader out it . I have no where to ride here but I could alway visit my uncle in ohio.

there is always some place to ride

I need to work on the clutch pedal tomorrow it stops good but I have to pull it back up with my foot.

the linkage may be scrapping on something

I decided to scrap it and keep the motor and front tires and wheels cause their new. I'm hoping to find a better one on craigslist this one is in bad shape.

save the tranny to! you may need one.

1997 Murray wrote:

save the tranny to! you may need one.

also the gas tank, the seat, all the pulleys you can, keep any bolts that have the nuts, the steering wheel, keep the rear fender's you can turn them into front fenders later on,