Peerless 820 input shaft bearing

Subject: Peerless 820 input shaft bearing July 19th 2015, 12:21 pm

Does anyone have any tricks for removing the bearing on the input shaft of a peerless 820. It went out and locked the rear end up. I got the seal out on the inside already but the bearing ain't budging. The way it looks is it slides out the inside.

Subject: Re: Peerless 820 input shaft bearing July 19th 2015, 6:48 pm

If you laid it on a flat surface, you could probably pound it out with a bearing race + seal driver, or a socket that is about the same or slightly smaller in diameter than the bearing.

Head Forum Administrator ** Chat Moderator ** Facebook Page Admin
ATLTF Facebook Page ** Chatbox ** How To Upload Pictures

_X_ FORUM ANNOUNCEMENTS _X_

Have a question? Ask me! Type in "@Doug" in your post!

Your ATLTF Staff:
Administrators: @Doug, @MightyRaze, @"Doc Sprocket", @Stretch44875
Moderators: @TheRainbowBoxer, @AllisKidD21, @Brianator, @RichieRichOverdrive

Subject: Re: Peerless 820 input shaft bearing July 19th 2015, 7:02 pm

I got it eventually. Used a socket and a lot of pounding and pb. Times like this a hydraulic press sure would be nice.

Subject: Re: Peerless 820 input shaft bearing September 29th 2015, 9:43 pm

Where is the best place to get input shaft bearings. I have one that locked up also because of it. Also has anyone changed from needle bearing to ball bearing. Wondering if they would hold up better. Thanks.

» Spicer 4360 89 input shaft needle bearing.
» Play in input shaft Peerless MST 206
» Peerless 900 series input shaft size
» Leaking input shaft
» Honda vertical shaft kart with peerless 700.