How to install a PTO rear drive on your tractor

I used the spacers i had created from the pulley spacers to make up the jokey wheel this mounted up fine I greased thoroughly. I had used 10mm bolts all around instead of the standard bolts I hoped this would make it stronger.



I received the accessory adapter back from the zinc platers it looks fabulous


I replaced the body work to check clearance and bolted it down.

do you have a attachment for this tractor on why your doing this? I've been wondering....

Ariens YT11 wrote:

do you have a attachment for this tractor on why your doing this? I've been wondering....

Not yet am intending to yes or will make something am considering converting a Shredder from a Countax

Fitted Adapter bar need a wigget to hold it up .

Am considering a Countax mechanism to do this as the existing leavers requires slots cut for them to function. These also have their operational parts under the chassis were they are subject to damp and rust. I am hoping the Countax PGC Lift Linkage  I have purchased will do a better job it may need some work to integrate it.




Am waiting for this to arrive as the 2009 tractor had the same chassis and mine and this similar mechanism

Rear lift from Countax T1600 turned up and is in great condition have took of the flap and de revited it and cleaned up all of the bright work. Am thinking that I may replace the Westwood lift for this as the countax accessories are more available still.